Installation of Tube Furnace Fitting Tee

1.Set the sealing ring into the flange outer interface: the sealing ring plays a closed role, is a very important part.

2.Put the size of the adapter: matching to the required adapter.

3.Will be placed on the fast flange sealing size of the transfer interface: flange does not require a practical tool, hand-tightening can be.

4.Tighten the shortcut flange fixed: sealing size adapter.

5.Fixed after installation as shown in the figure: flange does not require a practical tool, hand-tightening can be.

6.Connect the tee: tee for vacuum exhaust dual-use devices, do not affect each other.

7.Fix the tee with a fast flange: the clamp does not require the use of tools, hand-tightened can be.

8.Installation of vacuum pump bellows: bellows have the advantages of flow up to high sealing degree, easy to dismantle and so on.

9.After installation as shown in the figure: bellows with flow up to high sealing degree, easy to disassemble and other advantages.

10.Disassemble the clamp on the suction port of TAT vacuum pump: the original TAT vacuum pump suction port comes with a clamp.

11.Install the baffle valve to the vacuum pump suction port: the role of the baffle valve is to control the gas flow switch.

12.Baffle valve installed as shown in the picture: tighten the clamp without the use of tools, hand tightening can be.

Baffle valve plus sealing ring, bellows connection baffle valve: sealing ring plays a closed role, is a very important part.

14.Bellows baffle valve connected as shown in the picture: the sealing ring plays a closed role, is a very important part.

You can control the gas flow through the baffle valve: rotate it to the left and right to control the flow switch.

16.All installed as shown in the picture: Tee can help users to maintain the same pressure inside and outside the case of gas discharge.